The short answer: power is energy per unit time, and the watt is one joule per second: 1 W = 1 J/s. One kilowatt is exactly 1,000 W. Mechanical horsepower is 550 ft·lbf/s = 745.699871582 W, while metric horsepower is 735.49875 W and electric horsepower is exactly 746 W. For heating and cooling, 1 BTU(IT)/h = 0.2930710702 W, so 12,000 BTU/h — one refrigeration ton — is 3,516.85 W. Thus 2 kW = 2.682 hp, 100 hp = 74.57 kW, and 5,000 BTU/h = 1,465 W.

Key takeaways

  • 1 W = 1 J/s. Power is a rate, not an amount of energy.
  • 1 kW = 1,000 W exactly. Mega and milli follow the same decimal ladder.
  • Horsepower has several definitions. Mechanical is 745.699871582 W; metric is 735.49875 W, about 1.4% smaller.
  • 1 BTU/h = 0.2930710702 W. 12,000 BTU/h is one ton of refrigeration, or 3,516.85 W.
  • W is not Wh, and BTU/h is not BTU. The time denominator is the difference.

Power is a rate of energy transfer

Power tells you how quickly work is done or energy is moved. The SI unit is the watt, defined as one joule per second: 1 W = 1 J/s. A 60 W lamp converts 60 J of electrical energy every second; a 2 kW kettle converts 2,000 J/s. The same watt measures mechanical output, electrical input, and heat flow, which is why it is the common currency for comparing devices that do very different jobs.

Power is not energy. Energy is power multiplied by time, so a 1,000 W appliance running for one hour uses 1,000 Wh or 1 kWh. A high-power device can use less energy than a low-power one if it runs for a much shorter time. This distinction is the source of most confusion on electricity bills, where the unit is the kilowatt-hour rather than the kilowatt.

Watt and kilowatt are exact decimal steps

The SI prefixes are decimal: 1 kW = 1,000 W, 1 MW = 1,000 kW = 1,000,000 W, and 1 mW = 0.001 W. The step is always 1,000, never 1,024. A 1,500 W heater is 1.5 kW; a 250 mW laser is 0.25 W; a 2 MW wind turbine is 2,000 kW.

Kilowatts are the practical unit for household and industrial loads because a watt is small. A phone charger may draw 5–20 W, a laptop 45–100 W, a microwave 1,000–1,500 W, and an electric vehicle charger 7–22 kW. The same device can be described in W or kW without changing its actual consumption; only the number and the prefix change.

Horsepower has several definitions

Mechanical horsepower, also called imperial or SAE horsepower, is defined as 550 foot-pounds-force per second. With 1 lbf = 4.4482216152605 N and 1 ft = 0.3048 m, that is 745.699871582 W. The definition is exact under standard gravity. It is the horsepower used for most US car and motor ratings.

Metric horsepower, or PS, is 75 kilogram-force metres per second: 75 × 9.80665 = 735.49875 W. It is about 1.4% smaller than mechanical horsepower, so a 100 PS engine is about 98.6 hp. Electric horsepower is defined as exactly 746 W, and boiler horsepower is about 9,809.5 W. A rating without a definition can therefore be ambiguous by more than a percent.

BTU per hour is a rate, not an amount

The British thermal unit is an amount of energy, and BTU per hour is a rate. The International Table BTU is 1,055.05585262 J, so 1 BTU/h = 1,055.05585262 / 3,600 = 0.2930710702 W. One watt is therefore about 3.412141633 BTU/h, and one kilowatt is about 3,412.14 BTU/h.

Air-conditioning and heating equipment use BTU/h for capacity. One ton of refrigeration is 12,000 BTU/h, or 3,516.852842 W. A 3-ton unit is 36,000 BTU/h, or 10.55 kW of cooling. The number describes heat moved, not electrical power consumed; a 3-ton air conditioner does not draw 10.55 kW from the wall, because its coefficient of performance is greater than one.

Worked conversions

2 kW to horsepower. 2,000 / 745.699871582 = 2.6820 mechanical hp. In metric horsepower it is 2,000 / 735.49875 = 2.7192 PS.

100 hp to kilowatts. 100 × 745.699871582 = 74,569.99 W = 74.57 kW. The rounded 746 W definition would give 74.6 kW, a difference of 0.04%.

5,000 BTU/h to watts. 5,000 × 0.2930710702 = 1,465.36 W, or 1.465 kW.

3 tons of cooling to watts. 36,000 × 0.2930710702 = 10,550.56 W, or 10.55 kW. This is thermal capacity, not electrical input.

1,500 W to BTU/h. 1,500 × 3.412141633 = 5,118.21 BTU/h. A 1.5 kW heater is therefore a little over 5,000 BTU/h.

Power versus energy on a bill

Electricity is billed in kilowatt-hours, not kilowatts. A 2 kW heater running for 3 hours uses 6 kWh; a 100 W fan running for 60 hours also uses 6 kWh. The power rating tells you the instantaneous draw, and the duration turns it into the billed quantity. Duty cycle matters: a device that cycles on and off at 50% uses half the energy of one that runs continuously at the same rated power.

Startup surges are another difference between a rating and a measurement. Motors and compressors can draw several times their running current for a fraction of a second, which is why a generator or inverter must be sized for surge as well as continuous load. The conversion between W and hp describes the steady rating, not the startup peak.

What a rating actually measures

A motor nameplate may show input watts, output horsepower, or both. Output is shaft power; input is electrical draw. Because the motor has losses, input is always higher than output, and the ratio is the efficiency. A 1 hp motor that is 90% efficient draws about 829 W, not 746 W. Comparing an output rating with an input rating overstates the difference between two machines.

Vehicle horsepower can be measured at the crankshaft, at the wheels, or at the battery for an electric car. Air-conditioner capacity is heat moved, not electricity consumed. A generator may be rated for continuous or standby service. Before converting, identify which quantity the number describes; a correct unit conversion of the wrong quantity is still the wrong answer.

Common mistakes

Mixing horsepower definitions. Mechanical, metric, electric, and boiler horsepower differ. A 100 hp US rating is not 100 PS, and the gap is about 1.4%.

Confusing W with Wh. A watt is a rate; a watt-hour is an amount. Multiplying by hours is required to get energy.

Treating BTU and BTU/h as the same. BTU is energy; BTU/h is power. A 12,000 BTU/h unit is not a 12,000 BTU unit.

Comparing input and output ratings. An electric motor’s input power is higher than its shaft output because of losses. Compare like with like.

Assuming a resistive load. Motors, compressors, and power supplies have power factor and efficiency, so VA is not W. The conversion applies to real power, not apparent power.

Rounding and precision

The mechanical horsepower factor is exact under the standard definitions, but published ratings are rounded. Using 745.7 W instead of 745.699871582 W changes a 100 hp result by 0.00002%, which is far below any measurement uncertainty. The metric-versus-mechanical gap of 1.4% is much larger and worth stating explicitly when comparing international specifications.

Carry three or four significant figures for ordinary work and six or more for engineering analysis. Convert tolerances with the same factor: a ±5% rating of 10 kW is ±0.5 kW, or ±0.67 hp. Do not round to 746 W and then convert a large number of units, because the small per-unit error can become visible. In every case, state which horsepower definition and which BTU definition were used.

Frequently asked questions

How many watts are in one horsepower?

745.699871582 W for mechanical horsepower. Metric horsepower is 735.49875 W, and electric horsepower is exactly 746 W.

How many horsepower are in one kilowatt?

1.34102 mechanical hp. Divide kilowatts by 0.7456998716, or multiply by 1.34102.

How many BTU/h are in one kilowatt?

3,412.141633 BTU/h. Multiply kilowatts by that factor, or multiply watts by 3.412141633.

Is BTU/h the same as BTU?

No. BTU is an amount of energy; BTU/h is a rate of energy transfer. The time denominator is the difference, just as it is between W and Wh.

How many watts is 12,000 BTU/h?

3,516.85 W. That is one ton of refrigeration, a common capacity rating for air conditioners.

Why do air conditioners use BTU/h instead of watts?

BTU/h describes cooling capacity — heat removed — while watts would describe electrical input. The two are related by efficiency but are not the same number.

Further reading

Keep exploring

Read next Hex to RGB: Color Codes, Channels, and Alpha A hex code is three base-16 channel values in one string. Learn how RR, GG, and BB become… Read next Density Conversion: kg/m³, g/cm³, and lb/ft³ Density is mass per volume, and the metric and imperial units are linked by exact factors. Learn the… Read next Base Conversion: Binary, Decimal, Hex, and Place Value Convert integers between binary, octal, decimal, and hexadecimal, with place-value arithmetic, direct bit grouping, exact limits, and the…