What this calculator does
This pace calculator turns a distance and a finish time into a pace and a speed. Runners usually think in pace, such as minutes per mile, while walkers and cyclists often think in speed, such as miles per hour. The two are reciprocals, so a 9:41 mile is the same effort as 6.2 mph. Use it to plan race splits, to check whether a route matches your goal pace, or to convert a treadmill speed into minutes per mile.
Is this the right calculator?
Use it when
- You want running pace, finish time, or distance from the other two values.
- You are planning a 5K, 10K, half, or full marathon effort.
Use something else when
- You need cycling, swimming, or rowing pace; the units differ.
- You need a training plan or heart-rate-based workout prescription.
What changes the result most
| Distance | A longer distance at the same pace takes more time. |
|---|---|
| Target time | A faster finish time requires a faster pace. |
| Units | Miles and kilometers change the number but not the underlying effort. |
How to use it
- Enter the distance you covered.
- Choose miles or kilometers.
- Enter the time in hours and minutes.
- Review the pace per mile or kilometer and the average speed.
- Switch units to compare the same effort in the other system.
How it works
Example calculations
Example 1: 6.2 miles in 1:00
Sixty minutes for 6.2 miles gives 9:41 per mile and an average speed of 6.2 mph. That distance is very close to a 10K, so the pace is a realistic 10K estimate.
Example 2: 5 kilometers in 30:00
Thirty minutes over 5 kilometers gives 6:00 per kilometer and 10.0 kph. In miles, the same run is about 3.1 miles at 9:39 per mile, or 6.2 mph.
Example 3: 13.1 miles in 2:00
Two hours for 13.1 miles gives 9:10 per mile and 6.55 mph. A half marathon at that pace finishes in a little over two hours, so the run sits close to that mark.
What the result means
Pace and speed describe the same run from opposite directions. Pace is more useful for pacing a race because mile or kilometer markers line up with the numbers, and corrections are easy: if you are 10 seconds per mile slow at the halfway point, you know what to make up. Speed is more useful on a treadmill, a bike, or a rowing machine, where the display shows distance per hour. Averages hide variation, though. A 9:41 average can come from steady running or from fast miles followed by a slow finish, and hills, wind, and heat change the effort behind the same number. Use the average as a target and expect conditions to cost time.
Common mistakes
- Mixing units, such as entering a 5K distance with a per-mile goal.
- Entering 1:00 as one minute instead of one hour.
- Rounding the pace before converting the seconds.
- Treating an average pace as a steady pace.
- Comparing a treadmill pace with an outdoor pace without allowing for the difference.
Assumptions and limits
- The distance is measured accurately and the course is flat.
- The time is the full elapsed time for that distance.
- Pace is an average over the whole distance, not a split.
- One mile equals 1.609344 kilometers.
- Stops, walks, and pauses are included in the total time.
Frequently asked questions
What is the difference between pace and speed?
Pace is how long one mile or kilometer takes, in minutes per unit. Speed is how many units you cover in an hour. A 10:00 mile is 6.0 mph.
How do I convert pace to speed?
Divide 60 by the pace in decimal minutes. A 9:41 pace is 9.683 minutes, and 60 / 9.683 is about 6.2 mph.
What counts as a good pace?
It depends on fitness, age, terrain, and goals. A comfortable conversational pace is a better training guide than a number pulled from a chart.
Can I use this for walking or cycling?
Yes. Enter the distance and time and read either number. Cyclists usually watch speed, and walkers often use minutes per mile.
Why is my race pace different from training?
Races add adrenaline, crowding, and course changes, and training runs often include hills or stops. Compare like with like before drawing conclusions.
How do I convert a 5K time to a 10K?
There is no reliable shortcut. Longer races are usually run at a slower pace per mile, so use a recent race and add time for the extra distance.
Sources
2026 update
How to use the professional output
This page is not just a formula box. The result is designed to be checked, compared, and taken away.
- Professional worksheet. The result includes the inputs used, the method and scope, and a one-variable sensitivity check for finance calculators.
- A/B scenarios. Save two input sets in the browser and compare the primary, secondary, and breakdown figures side by side.
- Print / PDF and CSV. Print a branded worksheet, or export the year-by-year table when the calculator produces one.
The formulas and assumptions above still govern the number. The worksheet makes the estimate auditable; it does not make it a lender quote, tax return, or personalized advice.
Go deeper
