Skip to content

Generator Size Calculator

Enter the total running load, the extra startup surge of the largest motor, a safety margin, the voltage, and the power factor. The calculator sizes for the larger of the continuous and surge demands. A 2,500 W running load with 1,800 W of startup surge and a 25% margin needs about 5.38 kW, or 6.72 kVA at a 0.8 power factor.

Updated 2026-11-19 Editorial estimate Calccc Editorial Team Free · No sign-up
W
W

The startup surge of the largest motor, above its running watts.

%
V

Generators are rated in kVA; a power factor of 0.8 is common for mixed loads.

Scenarios A/BSave two input sets and compare the results. Stored only in this browser.
AEmpty
BEmpty

Your inputs stay in this browser. No account, no uploads.

Professional worksheet

Detailed schedule & assumptions

Inputs used, method, sensitivity, and any year-by-year table. The summary above stays compact; the audit lives here.

Professional worksheet

Inputs, scope, and sensitivity

Inputs used

Method and scope

Result audit

MetricValue

What this calculator does

A generator has two ratings that matter: the continuous or running rating and the short-term surge rating. Lights, heaters, and electronics draw close to their label wattage all the time, so they add up simply. Motors are different. A fridge, a well pump, or a circular saw can draw several times its running current for a fraction of a second when it starts, and the generator has to survive that moment without stalling or tripping. That is why a generator sized only on running watts can fail on the first hot day when the fridge compressor kicks in. The safe approach is to add the running loads, add the startup surge of the largest motor, apply a margin, and then compare the result with both the continuous and surge ratings of the generator. This calculator does that arithmetic and converts the result to kW, kVA, and current so the spec sheet and the load list can be compared in the same units.

How to use it

  1. Add up the running watts of everything you want to power at the same time.
  2. Find the largest motor's startup surge above its running watts and enter that extra figure.
  3. Choose a safety margin, typically 20% to 30%.
  4. Enter the system voltage, such as 230 V for a single-phase supply.
  5. Enter the power factor, which is about 0.8 for mixed loads.
  6. Compare the kW and kVA result with the generator's continuous and surge ratings.

How it works

Continuous demand = running watts × (1 + margin / 100). Surge demand = (running watts + startup surge) × (1 + margin / 100). Generator size = max(continuous demand, surge demand). kVA = size / (1000 × power factor). Current = size / voltage. In the default case the continuous demand is 3,125 W, the surge demand is 5,375 W, and the generator size is 5,375 W, or 5.38 kW and 6.72 kVA at 0.8 power factor.

Example calculations

Example 1: A fridge, lights, and a router

A small backup setup runs 2,500 W of lights, a fridge, and network equipment, with 1,800 W of extra startup surge from the fridge compressor. With a 25% margin the surge demand is (2,500 + 1,800) × 1.25 = 5,375 W, so a generator with at least 5.4 kW of surge capacity is needed. A 3 kW unit that only covers the running load would stall when the compressor starts.

Example 2: A well pump and a workshop

A well pump with 4,000 W of running load and 8,000 W of startup surge dominates a workshop list that totals 6,000 W running. The surge demand is (6,000 + 8,000) × 1.25 = 17,500 W, so the pump sets the size. The running demand is only 7,500 W with the margin. This is a common pattern: one large motor determines the generator, and the rest of the load barely matters.

Example 3: A resistive load with no motors

A heater and lighting load of 4,000 W has no startup surge. With a 20% margin the size is 4,800 W, or 6 kVA at 0.8 power factor. Because there is no surge, the continuous and surge demands are the same, and a smaller generator can be used than a motor-heavy list with the same running watts would require.

What the result means

The kW figure is the real power the generator can deliver, and the kVA figure is the apparent power the alternator must supply. A generator rated at 6 kVA with a 0.8 power factor delivers about 4.8 kW, so comparing a load in kW with a generator in kVA without the power factor can lead to an undersized choice. The surge margin is not a licence to run everything at once: the continuous rating is the limit for sustained use, and the surge rating is for short starts. Cold weather, altitude, and fuel quality can reduce output, and long extension leads add voltage drop. If the load list is close to the rating, step up a size rather than planning to run at the limit.

Common mistakes

  • Sizing only on running watts and ignoring motor startup surge.
  • Adding the startup surge of every motor instead of the largest one.
  • Comparing a load in kW with a generator rating in kVA without the power factor.
  • Running a generator indoors, in a garage, or near a window.
  • Using an extension lead that is too thin for the current and length.
  • Assuming the generator will deliver its full rating at altitude or in extreme cold.

Assumptions and limits

  • The startup surge entered is the extra watts above running for the largest motor.
  • The power factor is 0.8 unless a different value is entered.
  • The generator is single-phase and running at sea level in moderate conditions.
  • The load list is the simultaneous load, not the sum of every appliance in the building.
  • No derating for altitude, temperature, or fuel quality is applied.
  • The generator's continuous and surge ratings are both checked against the result.

Frequently asked questions

What size generator do I need?

Add the running watts, add the startup surge of the largest motor, apply a margin of 20% to 30%, and compare the result with both the continuous and surge ratings. In the default case that is about 5.4 kW.

What are surge watts?

Surge watts are the short-term extra power a motor draws when it starts. They last for a fraction of a second but can be several times the running watts, and the generator must be able to supply them without stalling.

What is the difference between kW and kVA?

kW is real power, which does work. kVA is apparent power, which the alternator must supply. They are related by the power factor: kW = kVA × power factor. A 0.8 power factor means 6 kVA delivers about 4.8 kW.

Can I run a fridge on a generator?

Yes, if the generator's surge rating covers the compressor startup. A fridge may run at 150 W but draw several hundred watts for a moment at startup. Use the surge figure rather than the running figure when sizing.

How much margin should I add?

A margin of 20% to 30% is common. It covers small loads you forgot, voltage drop, and the fact that generators are happiest below their maximum. A larger margin is safer but costs more and may run inefficiently at light load.

Can I parallel two smaller generators?

Some inverter generators support parallel operation with a kit from the same manufacturer. It can be a good option for occasional large loads, but the parallel kit, the load balance, and the combined surge rating all need to be checked.

Sources

This calculator is an educational planning tool, not financial, legal, insurance, medical, or professional advice. Results depend on the inputs and on rules that vary by place and provider. Confirm important decisions with a qualified professional and the relevant documents.

2026 update

How to use the professional output

This page is not just a formula box. The result is designed to be checked, compared, and taken away.

  • Professional worksheet. The result includes the inputs used, the method and scope, and a one-variable sensitivity check for finance calculators.
  • A/B scenarios. Save two input sets in the browser and compare the primary, secondary, and breakdown figures side by side.
  • Print / PDF and CSV. Print a branded worksheet, or export the year-by-year table when the calculator produces one.

The formulas and assumptions above still govern the number. The worksheet makes the estimate auditable; it does not make it a lender quote, tax return, or personalized advice.

Calccc Editorial Team · Updated 2026-11-19

Prepared by Calccc Editorial Team as an educational estimate. This page is not a licensed professional review and is not financial, medical, legal, or tax advice.

Editorial estimate prepared by the Calccc Editorial Team; not a licensed professional review.