The short answer: area is the amount of flat surface a shape covers, and it is always reported in square units. Multiply two perpendicular lengths — length × width for a rectangle, base × height ÷ 2 for a triangle, π × r² for a circle — then label the result with the square of the unit you measured in.

Key takeaways

  • Area is two-dimensional. It multiplies two lengths, so the unit is squared: ft², m², in².
  • Each shape has its own formula. Rectangle, triangle, circle, and trapezoid are not interchangeable.
  • Height is perpendicular. A slanted side is not the height of a triangle or a trapezoid.
  • Conversion factors get squared. 1 ft = 12 in, so 1 ft² = 144 in², not 12 in².
  • Order area with waste. Add 5–10% for cuts before buying paint, tile, or flooring.

What area measures

Area counts the unit squares needed to cover a flat region. A rectangle 12 feet by 10 feet holds 120 squares that are one foot on each side, so its area is 120 square feet, written 120 ft². Perimeter measures the distance around the edge instead, and the two numbers are not interchangeable. A 10 ft × 10 ft room and a 20 ft × 5 ft room both have 100 ft² of floor, but their perimeters are 40 ft and 50 ft. Baseboard, trim, and fencing use perimeter; paint, flooring, and seed use area.

Rectangle and square: length × width

A rectangle’s area is A = l × w, and a square is the special case A = s². For a room 12 ft by 10 ft, A = 12 × 10 = 120 ft² and the perimeter is 2 × (12 + 10) = 44 ft. In metric, a wall 2.5 m by 4 m is 10 m². Squares are worth checking because the exponent is easy to forget: a 3 m square has an area of 9 m², not 6 m². A parallelogram uses the same rule with a perpendicular height rather than a slanted side.

Triangle: base × height ÷ 2

A = ½ × b × h, where h is the perpendicular height from the base to the opposite vertex. A triangle with base 8 and height 5 has an area of ½ × 8 × 5 = 20 square units. The ½ is there because a triangle fills exactly half of the rectangle that encloses it. When all three sides are known but the height is not, Heron’s formula works from the semiperimeter s = (a + b + c) ÷ 2. For sides 5, 6, and 7, s = 9 and A = √(9 × 4 × 3 × 2) ≈ 14.70 square units.

Circle: π × r²

A = π × r², where r is the radius. A circle of radius 3 has an area of π × 9 ≈ 28.27 square units and a circumference of 2 × π × 3 ≈ 18.85 units. The radius is half the diameter, which matters on real objects: a 12-inch pizza has a 6-inch radius and an area of π × 36 ≈ 113.10 in², while an 18-inch pizza has a 9-inch radius and 254.47 in². The larger pie is 1.5 times as wide but 2.25 times the area, because area scales with the square of the radius.

Trapezoid: average the parallel bases

A = ((b₁ + b₂) ÷ 2) × h. The two bases must be parallel, and h is the perpendicular distance between them. Bases 6 and 10 with height 4 give A = ((6 + 10) ÷ 2) × 4 = 8 × 4 = 32 square units. Forgetting to divide the sum by 2 is the usual error and doubles the answer; using a slanted side as the height inflates it as well.

Choosing the formula

Shape What you measure Formula Example
Rectangle Length and width A = l × w 12 × 10 = 120
Square One side A = s² 7² = 49
Triangle Base and perpendicular height A = ½ × b × h ½ × 8 × 5 = 20
Circle Radius A = π × r² π × 3² ≈ 28.27
Trapezoid Two parallel bases and height A = ((b₁ + b₂) ÷ 2) × h 8 × 4 = 32

Match the measurement to the formula before you enter numbers. If the shape is a composite — an L-shaped room, a wall with a window — split it into rectangles and triangles, compute each part, and add. Subtracting an opening is the same operation with a negative: a 12 ft × 8 ft wall is 96 ft², a 3 ft × 7 ft door is 21 ft², and the paintable area is 75 ft².

Units: why area is squared and how to convert

Multiplying two lengths produces a squared unit, so a conversion factor is squared as well. Since 1 ft = 12 in, 1 ft² = 144 in². Since 1 yd = 3 ft, 1 yd² = 9 ft². Since 1 m = 3.28084 ft, 1 m² = 10.7639 ft², and 1 ft² = 0.09290304 m²; the two factors are exact reciprocals. Converting 120 ft² gives 120 × 0.09290304 ≈ 11.15 m². Land uses larger units: 1 acre = 43,560 ft² ≈ 4,046.86 m², and 1 hectare = 10,000 m² ≈ 2.471 acres.

Convert before you calculate, not after. A rectangle listed as 6 ft by 24 in must become 6 ft by 2 ft, giving 12 ft². Multiplying 6 by 24 produces 144, a number with no physical meaning. The same discipline applies to mixed metric input: 1.5 m by 80 cm is 1.5 m by 0.8 m, or 1.2 m².

Rounding, pi, and measured precision

Round once, at the end. Carrying 3.14 in place of π shifts the last digit — for radius 5 the area is 78.50 with 3.14 and 78.54 with π, a difference of about 0.05%. Measurement precision usually dominates: a room measured to the nearest inch is good to roughly 1 part in 100, so quoting 120.437 ft² overstates what the tape measure knows. Two decimal places suit a material estimate, and a whole number is honest for a room.

Keep significant figures sensible when the input has few. A radius given as “about 3 m” supports an area of about 28 m², not 28.2743 m². If a shape is measured in feet and inches, convert to a single decimal first; 5 ft 6 in is 5.5 ft, and squaring 5.5 is 30.25 ft².

Common mistakes

  • Using the diameter where the formula wants the radius, which quadruples a circle’s area.
  • Using a slanted side as the triangle or trapezoid height, which inflates the result.
  • Leaving out the ½ in the triangle formula, which doubles the area.
  • Adding the trapezoid bases without dividing by two.
  • Reporting ft, m, or in instead of ft², m², or in².
  • Mixing inches and feet in one multiplication.
  • Assuming that doubling every dimension doubles the area; it multiplies area by four.

Using area for paint, flooring, and tile

Order the calculated area plus a waste allowance. A 12 ft × 10 ft floor is 120 ft²; with 10% waste, buy 132 ft², because cuts, misreads, and damaged pieces consume the difference. Tile sold by the box needs a round up: 132 ft² ÷ 12 ft² per box = 11 boxes. At $4.50 per ft², 132 ft² costs $594. Paint follows the same logic in reverse: two coats on 75 ft² of wall need 150 ft² of coverage, and at 350 ft² per gallon that is about 0.43 gallon, so one gallon is the smallest sensible purchase.

For irregular shapes, break the region into rectangles and triangles, total the parts, then add waste, and round the final order up rather than the intermediate steps.

Frequently asked questions

Why is area measured in square units?

Because area counts unit squares that fit inside a shape. Multiplying two lengths produces a squared unit, which is why 12 ft × 10 ft is 120 ft² rather than 120 ft.

Can I find the area if I only know the perimeter?

Not in general. A 40 ft perimeter can enclose a 10 ft × 10 ft square with 100 ft² or a 15 ft × 5 ft rectangle with 75 ft². Area needs at least one dimension beyond the perimeter.

What is the difference between area and surface area?

Area describes a flat region. Surface area adds the areas of every face of a solid, so a 2 ft cube has a surface area of 6 × 4 = 24 ft² while each face is 4 ft².

How do I convert square feet to square meters?

Multiply by 0.09290304. A 120 ft² room is about 11.15 m². Going the other way, multiply square meters by 10.7639.

Does the shape with the larger perimeter always have more area?

No. For a fixed perimeter, the circle encloses the most area and a long thin rectangle encloses very little, so perimeter alone tells you nothing about area.

Is area ever negative?

No. Area is a physical coverage, so it is zero or positive. A negative result signals a subtraction error, such as removing a window larger than the wall.

Further reading

Keep exploring

Read next Logarithm: Base, Product Rule, and Scale A logarithm is an exponent in disguise. Learn the definition, the product, quotient and power rules, change of… Read next Order of Operations: PEMDAS and Ambiguous Expressions PEMDAS is a shared convention, not a law of mathematics. Learn the real precedence rules, the exponent and… Read next Significant Figures: Counting, Rounding, and Precision Significant figures record how precisely a value was measured. Learn the counting rules, the addition and multiplication rules,…