The short answer: Waist-to-hip ratio is your waist circumference divided by your hip circumference. A 32-inch waist and 40-inch hips give 0.80. For men, under 0.90 is low, 0.90 to 0.99 is moderate, and 1.00 or above is high; for women the bands are under 0.85, 0.85 to 0.89, and 0.90 or above. It is a screening estimate of where your body stores fat, not a diagnosis and not a body fat percentage.

Key takeaways

  • One division, no units. Waist divided by hip, measured in the same unit.
  • Cutoffs differ by sex. Men and women use different bands because fat distribution and risk differ.
  • The waist landmark matters. Use the midpoint between the lowest rib and the top of the hip bone.
  • A ratio can hide absolute size. Two very different bodies can share the same ratio.
  • Pair it with waist circumference. The ratio shows distribution; the tape shows scale.

What the ratio measures

Waist-to-hip ratio, usually shortened to WHR, compares the width of your waist with the width of your hips. It is a way of describing fat distribution. Fat stored around the abdomen, sometimes called central or android fat, is linked in research to higher metabolic and cardiovascular risk than fat stored around the hips and thighs. The ratio is a quick way to put a number on that pattern.

The measure is old, cheap, and surprisingly durable. It needs only a tape measure, and it does not change with the bathroom scale. What it cannot do is separate visceral fat, the fat around the organs, from subcutaneous fat just under the skin. It also cannot tell you how much muscle or bone is under the tape.

The formula

Waist-to-hip ratio = waist circumference / hip circumference

Measure both circumferences in the same unit, either centimetres or inches. Because the units cancel, the ratio itself has no unit: 0.80 is 0.80 whether you measured in inches or centimetres. Mixing units is the most common arithmetic error. A 32-inch waist divided by a 100-centimetre hip does not give a meaningful number.

Round the result to two decimal places. The difference between 0.84 and 0.85 is one band boundary for a woman, so rounding to one decimal place can move you across a category for no biological reason.

How to measure waist and hips

Measurement technique drives the result more than most people expect. A tape placed too high, too low, or over clothing can shift the ratio by several hundredths, which is enough to change a band.

Site Landmark Common error
Waist Midpoint between the lowest rib and the top of the hip bone Measuring at the navel or at the narrowest point
Hips Widest point of the buttocks, feet together Measuring at the hip bones or over a pocket
Tape Snug, level, not compressing the skin Tape sloping at the back
Breathing At the end of a normal exhale Holding the breath or pulling the stomach in

Stand relaxed, breathe normally, and take each measurement twice. If the two readings differ by more than a centimetre, reposition the tape and try again. Measure in the morning, before a large meal or a workout, and without a bulky layer of clothing.

The risk bands

The World Health Organization uses a waist-to-hip ratio of 0.90 or more in men and 0.85 or more in women as a marker of abdominal obesity. The calculator splits each sex into three bands so that a single number reads more clearly.

Band Men Women What it suggests
Low Under 0.90 Under 0.85 Below the common screening cutoff
Moderate 0.90 to 0.99 0.85 to 0.89 At or just above the cutoff
High 1.00 or above 0.90 or above Well above the cutoff

These bands are screening tools, not risk scores. They were built from population studies, and they describe how risk tends to rise across groups. An individual at the top of the moderate band is not destined for a health problem, and an individual in the low band is not guaranteed to be healthy.

Worked examples

Waist Hips Ratio Sex Band
32 in 40 in 0.80 Male Low
30 in 38 in 0.79 Female Low
40 in 42 in 0.95 Male Moderate
36 in 38 in 0.95 Female High

The last two rows make the sex-specific cutoffs concrete. The same ratio of 0.95 is moderate for a man and high for a woman. The arithmetic is identical; only the interpretation changes.

Why the ratio hides absolute size

A ratio is scale-free, which is both its strength and its weakness. A 24-inch waist with 30-inch hips gives 0.80. A 44-inch waist with 55-inch hips also gives 0.80. The first body is small, the second is large, and the second carries a waist circumference that most guidelines treat as a substantially increased risk on its own.

That is why the ratio should never travel alone. Waist circumference captures absolute abdominal size, while the ratio captures the balance between waist and hips. A person can have a low ratio because of wide hips and still have a waist that deserves attention. Reading both numbers together closes most of that gap.

Companion measures

Waist circumference is the natural partner. Widely used thresholds place increased risk at roughly 94 cm (37 inches) for men and 80 cm (31.5 inches) for women, with substantially increased risk at roughly 102 cm (40 inches) and 88 cm (35 inches). Waist-to-height ratio is another simple check: keeping the waist under half your height is a common rule of thumb.

Measure Men Women
Waist, increased risk About 94 cm (37 in) About 80 cm (31.5 in)
Waist, substantially increased About 102 cm (40 in) About 88 cm (35 in)
Waist-to-height, upper guidance Keep the waist below half of height (0.50)

BMI still has a role as a population and clinical screening measure, but it says nothing about distribution. A person with a normal BMI and a high waist-to-hip ratio can carry more risk than the BMI alone suggests.

What the number cannot tell you

Waist-to-hip ratio does not measure visceral fat directly, does not diagnose metabolic syndrome, and does not account for ethnicity-specific cutoffs. It can mislead during pregnancy, after abdominal surgery, or when swelling changes the waist. Very muscular people may carry enough mass in the hips and thighs to lower the ratio without changing their abdominal fat. Older adults may lose height and muscle, which changes the waist landmark.

It also says nothing about blood pressure, glucose, lipids, smoking, family history, or fitness. Those are the variables that turn a body measurement into a risk conversation.

Common mistakes

  • Measuring the waist at the navel. The WHO protocol uses the midpoint between the lowest rib and the hip bone.
  • Mixing inches and centimetres. Convert first; the ratio only works in one unit.
  • Pulling the tape tight. A compressed waist reads smaller and inflates the apparent hip ratio.
  • Rounding too early. Two decimal places preserve the band boundaries.
  • Using the ratio as a body fat test. It describes distribution, not composition.
  • Comparing your number with someone else’s. Cutoffs are sex-specific and population-based; your trend is more useful.

Tracking and when to talk to a clinician

If you track WHR, measure under the same conditions every four to six weeks. A change of 0.02 or more is worth noting; smaller movements are usually measurement noise. Pair the trend with waist circumference, body weight, and how clothes fit.

If your ratio sits in the moderate or high band, or has moved recently, bring it to a clinician rather than trying to interpret it alone. A waist measurement is one input among many, and the useful next step is usually a broader check of blood pressure, blood glucose, and lipids. This article is education, not medical advice.

Frequently asked questions

Is a 0.9 waist-to-hip ratio good?

It depends on sex. For a man, 0.90 is the boundary between low and moderate. For a woman, 0.90 is the start of the high band. The number means different things because the cutoffs differ.

Where exactly should I measure my waist?

At the midpoint between the lowest rib and the top of the hip bone, at the end of a normal exhale, with the tape snug and level. Do not measure at the navel.

Does waist-to-hip ratio replace BMI?

No. BMI captures overall size and is used widely in clinical screening. WHR captures distribution. They answer different questions and are most useful together.

Can I use centimetres instead of inches?

Yes, as long as both measurements use the same unit. The ratio is unitless, so 32 divided by 40 is the same as 81 divided by 102, give or take rounding.

Why do the cutoffs differ by sex?

Men and women store fat differently, and the risk associated with a given ratio differs. The bands reflect population evidence, not a claim that one body type is better.

Can athletes have a high waist-to-hip ratio?

They can, but muscular hips and thighs often lower the ratio. A low ratio does not rule out a high waist circumference, so check both numbers.

What the calculator does: it divides your waist measurement by your hip measurement and places the result in a low, moderate, or high band using sex-specific cutoffs. It does not measure body fat and does not account for age, ethnicity, or medical history.

This is health education, not medical advice. Waist-to-hip ratio is a screening estimate, and cutoffs vary by population and guideline. Discuss a moderate or high reading, or a sudden change, with a qualified clinician.

Further reading

Keep exploring

Read next Waist-to-Height Ratio: Screening Bands and Limits Waist-to-height ratio compares waist circumference with height. Learn the 0.5 guide, how to measure consistently, the screening bands,… Read next VO2 Max: Estimates, Units, and Training Context VO2 max is the highest rate at which you can use oxygen during exercise. Learn the units, the… Read next Heart Rate Recovery: One-Minute Drop and Fitness Trends Heart rate recovery is the drop in beats per minute one minute after you stop exercising. See the…