What this calculator does
Sweat is mostly water, but it also carries sodium, potassium, and other electrolytes. The sodium concentration varies enormously between people and even for the same person as they heat-acclimatise, so a generic sports drink is not a personalised replacement plan. This calculator starts from a measured or estimated sweat rate, multiplies by exercise time, and applies the sodium and potassium concentrations you enter. It then applies the share you intend to replace and converts sodium to a salt equivalent. The result is a planning estimate for food and fluids, not a prescription. It is especially useful for long or hot sessions where plain water alone can dilute the sodium in the body, and for comparing your sweat losses with what a drink or meal actually provides.
How to use it
- Estimate sweat rate from weight change plus fluid drunk during a similar session.
- Enter the exercise time in hours.
- Enter sweat sodium concentration from a sweat test, or a reasonable estimate.
- Enter sweat potassium concentration, which is usually much lower.
- Choose the share of the loss you want to replace.
- Spread the replacement across fluids and food before, during, and after exercise.
How it works
Example calculations
Example 1: 1.5 hours at 1 L/h
Sweat rate is 1 L/h for 1.5 hours, so sweat volume is 1.5 L. At 900 mg/L sodium, the sodium loss is 1,350 mg; at 200 mg/L potassium, the potassium loss is 300 mg. Replacing 80% means 1,080 mg of sodium, 240 mg of potassium, and 1.2 L of fluid. The sodium is equivalent to about 2.75 g of salt.
Example 2: A long hot session
At 1.2 L/h for 3 hours, sweat volume is 3.6 L. At 1,000 mg/L sodium, the loss is 3,600 mg; at 180 mg/L potassium, 648 mg. Replacing 90% means 3,240 mg of sodium and 583 mg of potassium, with 3.24 L of fluid. That is a large sodium load, so spread it across food and drink rather than taking it all at once.
Example 3: A short, cooler session
At 0.6 L/h for 1 hour, sweat volume is 0.6 L. At 600 mg/L sodium, the loss is 360 mg, and at 150 mg/L potassium, 90 mg. Replacing 50% means 180 mg of sodium and 45 mg of potassium. For a short session, a normal meal and drink may cover this without a dedicated electrolyte product.
What the result means
The sodium to replace is the headline number, but the fluid to replace and the potassium line matter too. Sodium is the main electrolyte lost in sweat; potassium loss is much smaller. The share replaced is a planning choice, not a target set by the calculator. Replacing every milligram is rarely necessary, and over-replacing sodium or drinking excessive fluid can both be problems. The salt equivalent helps translate milligrams of sodium into the salt on a food label. Use the result alongside thirst, urine colour, weather, and the length of the session, and treat it as a starting point that you adjust from experience.
Common mistakes
- Using a generic sweat sodium figure without adjusting for heat, fitness, or individual variation.
- Replacing all sodium losses with salt tablets instead of food and drink.
- Drinking large volumes of plain water without any sodium during very long sessions.
- Forgetting that sweat rate changes as you acclimatise.
- Confusing milligrams of sodium with milligrams of salt.
- Using the calculator as a treatment plan for a medical condition or an eating disorder.
Assumptions and limits
- Sweat rate is constant for the whole session.
- Sweat sodium and potassium concentrations are constant during the session.
- The share replaced is applied evenly to fluid, sodium, and potassium.
- One gram of salt contains about 393 mg of sodium.
- Other electrolytes, such as magnesium and chloride, are not modelled.
- The estimate is for healthy adults without medical conditions that affect fluid or electrolyte balance.
Frequently asked questions
How do I measure my sweat rate?
Weigh yourself before and after a session, note how much you drank, and account for urine. The change in weight plus the fluid drunk, divided by the hours, gives a sweat rate. A 1 kg drop is roughly 1 L of sweat.
Where does the sweat sodium number come from?
A sweat test can measure it, but many people use an estimate. Typical values are roughly 500 to 1,500 mg per litre. The calculator uses whatever you enter, so choose a figure that reflects your own experience or a test.
Do I need to replace all the sodium I lose?
Not necessarily. The share replaced is your choice. Many sessions are short enough that normal meals and drinks cover the loss. Long, hot, or repeated sessions are where a more deliberate plan matters.
Is a salt tablet the same as salt?
No. Check the label: a salt tablet is not pure sodium chloride, and the sodium content varies. The calculator converts sodium to a salt equivalent so you can compare with food labels, but the product you use may differ.
Can I drink too much fluid?
Yes. Drinking far more than you sweat can dilute sodium in the body, which is dangerous. Replace according to thirst and your estimated losses rather than forcing large volumes.
Is this suitable if I have kidney or heart problems?
No. This calculator is general information for healthy adults. Kidney, heart, liver, and blood-pressure conditions, as well as some medications, change how sodium and fluid should be managed. Ask a clinician before using electrolyte supplements.
Sources
2026 update
How to use the professional output
This page is not just a formula box. The result is designed to be checked, compared, and taken away.
- Professional worksheet. The result includes the inputs used, the method and scope, and a one-variable sensitivity check for finance calculators.
- A/B scenarios. Save two input sets in the browser and compare the primary, secondary, and breakdown figures side by side.
- Print / PDF and CSV. Print a branded worksheet, or export the year-by-year table when the calculator produces one.
The formulas and assumptions above still govern the number. The worksheet makes the estimate auditable; it does not make it a lender quote, tax return, or personalized advice.