What this calculator does
The angle of a solar panel changes how much sunlight it intercepts. A panel lying flat collects less at high latitudes in winter, while a panel tilted too steeply loses some summer output. For a fixed roof or ground mount, the usual compromise is a tilt close to the latitude, adjusted by a rule of thumb. The approximation used here, 0.76 times the latitude plus 3.1 degrees, is one of several that produce similar results in the mid-latitudes. Winter output is improved by tilting steeper, and summer output by tilting flatter, which is why adjustable mounts use a seasonal range. The direction matters as much as the angle in the northern and southern hemispheres: panels face south in the north and north in the south. This calculator gives a practical starting angle, a seasonal range, and the direction to face, and it is honest about what it does not model.
How to use it
- Enter your latitude in degrees, using a negative number for the southern hemisphere.
- Choose year-round, winter, or summer output depending on what matters most.
- Read the recommended tilt and the direction to face.
- Check the seasonal range to see how much an adjustable mount would move.
- Compare the angle with your actual roof pitch before planning a mount.
- Confirm the result against a local yield model or installer before building.
How it works
Example calculations
Example 1: 40 degrees north
At 40 degrees north the year-round tilt is 0.76 × 40 + 3.1 = 33.5 degrees. Winter output is best at 48.5 degrees and summer at 18.5 degrees, so an adjustable mount would move through a 30-degree range. The panels face south at 180 degrees azimuth. A roof with a 30-degree pitch is close enough that the gain from a separate mount may not justify the cost.
Example 2: 25 degrees north
At 25 degrees north the year-round tilt is 22.1 degrees, winter is 37.1 degrees, and summer is 7.1 degrees. The lower latitude means a flatter angle and a smaller seasonal swing. On a flat roof the panels need less tilt and more row spacing becomes the constraint, because a flatter array shades the row behind it less than a steep one but also catches less low-angle sun.
Example 3: 33 degrees south
At 33 degrees south the latitude is entered as -33. The year-round tilt is still 0.76 × 33 + 3.1 = 28.2 degrees, but the panels face north at 0 degrees azimuth instead of south. Winter is 43.2 degrees and summer is 13.2 degrees. The southern hemisphere is a mirror image for direction; the tilt formula uses the absolute latitude.
What the result means
The tilt recommendation is a starting point, and the sensitivity is lower than many people expect. Around the year-round angle, a change of 10 degrees typically moves annual yield by only a few percent, so a roof that is already close to the angle is usually fine. The bigger effects come from shading, soiling, snow, and the direction the panels face. Winter optimisation matters most for off-grid systems and for high latitudes where winter production is already low. Summer optimisation matters for systems with cooling loads and time-of-use tariffs. Row spacing on a ground mount depends on the tilt, because a steeper array casts a longer shadow, so the tilt and the spacing should be designed together rather than in sequence.
Common mistakes
- Using the latitude directly as the tilt without the adjustment.
- Facing panels south in the southern hemisphere or north in the northern hemisphere.
- Optimising for summer when winter production is the limiting factor.
- Ignoring row spacing, so one row shades the next in winter.
- Assuming a small tilt change will produce a large yield change.
- Ignoring shading from trees, chimneys, or neighbouring buildings.
Assumptions and limits
- The mount is fixed, not tracking.
- There is no shading from nearby objects.
- The latitude and hemisphere are entered correctly.
- The rule of thumb applies to the mid-latitudes where it was derived.
- Local weather, snow, and soiling are not modelled.
- The result is a starting angle, not a bankable yield forecast.
Frequently asked questions
What is the best tilt angle for solar panels?
For a fixed mount, a common approximation is 0.76 times the latitude plus 3.1 degrees for year-round output. At 40 degrees north that is about 33.5 degrees. Local conditions and the roof pitch can justify a different angle.
Does the tilt angle matter much?
Less than shading and direction. Around the year-round angle, a 10-degree change usually moves annual output by only a few percent. A poor direction or a shaded panel costs much more than a few degrees of tilt.
Should I adjust the tilt between seasons?
If the mount allows it, tilting steeper in winter and flatter in summer can improve seasonal output. The gain is modest and the effort is only worthwhile if the mount is accessible and the seasonal load profile justifies it.
Which direction should solar panels face?
In the northern hemisphere they face south, about 180 degrees azimuth. In the southern hemisphere they face north, about 0 degrees. East or west orientations produce less total output but can better match morning or evening demand.
What about a flat roof?
Flat roofs usually use a tilted rack or a low ballasted mount. The tilt still follows the same rule, but row spacing has to be designed so the front row does not shade the row behind it in winter.
Does snow change the best angle?
A steeper angle helps snow slide off, which can matter more than the small annual yield difference. In snowy regions a steeper winter tilt is often chosen for practical reasons as well as production.
Sources
2026 update
How to use the professional output
This page is not just a formula box. The result is designed to be checked, compared, and taken away.
- Professional worksheet. The result includes the inputs used, the method and scope, and a one-variable sensitivity check for finance calculators.
- A/B scenarios. Save two input sets in the browser and compare the primary, secondary, and breakdown figures side by side.
- Print / PDF and CSV. Print a branded worksheet, or export the year-by-year table when the calculator produces one.
The formulas and assumptions above still govern the number. The worksheet makes the estimate auditable; it does not make it a lender quote, tax return, or personalized advice.