Skip to content

Laundry Cost Calculator

Enter your loads per week, the electricity and water used per load, the utility prices, and the detergent cost. The calculator returns the cost per load, per week, and per year, and separates the electricity and water shares.

Updated 2026-11-18 Editorial estimate Calccc Editorial Team Free · No sign-up
kWh

A modern machine on an eco cycle uses roughly 0.5 to 1.5 kWh; hot washes use more.

$/kWh
L
$/m³

1 m³ = 1,000 litres.

Advanced options
$
Scenarios A/BSave two input sets and compare the results. Stored only in this browser.
AEmpty
BEmpty

Your inputs stay in this browser. No account, no uploads.

Professional worksheet

Detailed schedule & assumptions

Inputs used, method, sensitivity, and any year-by-year table. The summary above stays compact; the audit lives here.

Professional worksheet

Inputs, scope, and sensitivity

Inputs used

Advanced inputs used

Method and scope

Result audit

MetricValue

What this calculator does

A laundry load costs more than detergent. The machine uses electricity to run and, if the water is heated, a lot more to warm it; it also uses water that is metered in many homes. Adding those pieces together gives a realistic cost per load and shows which part dominates. That matters when deciding whether to wash at a lower temperature, run fuller loads, or replace an old machine. This calculator uses metric units, a price per kilowatt-hour, and a price per cubic metre of water, so it works with a typical utility bill. It is an estimate for household budgeting, not a prediction of a specific machine's energy label.

How to use it

  1. Count the loads your household runs in a typical week.
  2. Find the electricity per load on the machine's energy label or estimate from a meter reading.
  3. Enter the electricity price from your bill.
  4. Enter the water used per load and the price per cubic metre.
  5. Add the detergent cost per load and read the annual total.

How it works

Cost per load = electricity (kWh) x price per kWh + water (L) / 1,000 x price per m³ + detergent. Annual cost = cost per load x loads per week x 52. In the default case, 1.2 kWh and 50 L per load give $0.74 per load and $191.10 a year.

Example calculations

Example 1: Five loads a week at 1.2 kWh

Each load costs $0.74, with electricity at $0.36 and water at $0.13. A year of washing costs $191.10 and uses 13,000 litres of water.

Example 2: No loads in the week measured

With zero loads and no detergent, the per-load cost is still $0.49 because it describes one load's energy and water. Weekly and annual totals fall to zero, which is a useful check that the multiplication is driven by the load count.

Example 3: Ten efficient loads at higher utility prices

A more efficient machine and lower water use still cost $0.60 per load at higher prices, or $312.00 a year for ten loads a week. Efficiency gains can be offset by higher tariffs and frequency.

What the result means

The electricity and water shares show where to focus. In the default example, electricity is the larger share, so a lower wash temperature or a more efficient machine matters more than a small change in detergent. Water and energy prices vary widely by region and tariff, and a time-of-use tariff can change the economics of running a machine at night. The estimate excludes the purchase price and depreciation of the machine, dryer energy, and standing charges, so the full cost of laundry is higher. It also assumes every load uses the same settings; a hot wash can use several times the energy of a cold one.

Common mistakes

  • Counting only detergent and ignoring electricity and water.
  • Using the machine's maximum rated power instead of energy per cycle.
  • Mixing dishwasher or dryer energy into the laundry figure.
  • Forgetting that water is billed per cubic metre, not per litre.
  • Ignoring time-of-use tariffs that change the price by hour.

Assumptions and limits

  • Every load uses the same energy, water, and detergent.
  • The electricity price is a single rate per kWh.
  • The water price is a single rate per cubic metre.
  • Detergent cost per load is constant.
  • Machine purchase, maintenance, and dryer energy are excluded.

Frequently asked questions

Is it cheaper to wash at 30 °C than at 60 °C?

Usually yes, because most of the electricity in a warm wash goes to heating the water. The exact saving depends on the machine, the load size, and the tariff, but lowering the temperature is one of the most effective changes for most households.

How much water does a washing machine use?

Modern front-loading machines typically use 40 to 60 litres per cycle, while older top-loaders can use 100 litres or more. Check the machine's manual or the energy label for a specific figure.

Should I include the cost of the machine?

This calculator covers running costs only. To include the machine, divide its purchase price by the expected number of loads over its life and add that to the per-load cost.

Does the detergent cost matter?

It is usually a small share compared with electricity for a warm wash, but it can be significant for cold washes and for premium products. Enter the real cost per dose rather than the pack price.

Why is the annual figure 52 weeks?

It assumes the weekly load count is a year-round average. If your washing pattern changes with the seasons, use an average weekly figure or calculate the summer and winter periods separately.

Can I use this for a shared laundry?

Yes, if you know the machine's energy and water use and the price you pay. For a coin-operated machine, add the per-cycle charge to the detergent line or treat it as a separate fixed cost.

Sources

This calculator is an educational household-cost estimate. It uses your inputs and does not predict a specific appliance's consumption. Check the energy label and your utility bill for exact figures.

2026 update

How to use the professional output

This page is not just a formula box. The result is designed to be checked, compared, and taken away.

  • Professional worksheet. The result includes the inputs used, the method and scope, and a one-variable sensitivity check for finance calculators.
  • A/B scenarios. Save two input sets in the browser and compare the primary, secondary, and breakdown figures side by side.
  • Print / PDF and CSV. Print a branded worksheet, or export the year-by-year table when the calculator produces one.

The formulas and assumptions above still govern the number. The worksheet makes the estimate auditable; it does not make it a lender quote, tax return, or personalized advice.

Calccc Editorial Team · Updated 2026-11-18

Prepared by Calccc Editorial Team as an educational estimate. This page is not a licensed professional review and is not financial, medical, legal, or tax advice.

Editorial estimate prepared by the Calccc Editorial Team; not a licensed professional review.