Skip to content

Aquarium Calculator

Enter the tank's length, width, and height, plus the substrate depth and how much rock or decor you plan. The calculator subtracts the displacement to give real water volume, then converts it into weight, a fish-length capacity, a heater wattage, and a filter turnover rate. The default 80 × 40 × 50 cm tank holds 128.0 litres of water.

Updated 2026-11-18 Editorial estimate Calccc Editorial Team Free · No sign-up
cm
cm
cm

Measure the glass height, not the water line. The calculation uses the full height.

cm

Gravel or sand displaces water. 5 cm is a typical planted-tank depth.

Advanced options
%

A rough share of the tank taken up by wood, rock, and equipment.

cm

Add the expected adult length of every fish you plan to keep.

Scenarios A/BSave two input sets and compare the results. Stored only in this browser.
AEmpty
BEmpty

Your inputs stay in this browser. No account, no uploads.

Professional worksheet

Detailed schedule & assumptions

Inputs used, method, sensitivity, and any year-by-year table. The summary above stays compact; the audit lives here.

Professional worksheet

Inputs, scope, and sensitivity

Inputs used

Advanced inputs used

Method and scope

Result audit

MetricValue

What this calculator does

Aquarium volumes are quoted as if the tank were a perfect empty box, but water never fills the whole box. Gravel, sand, wood, and rock all take up space, and the water line usually sits below the rim. The difference matters: a "160 litre" tank may hold only 128 litres once the substrate and decor are in, and every calculation that follows, from stocking to heater size to filter flow, should use the real water volume. Weight matters too, because water is heavy and a filled tank on an upper floor is a structural load, not just a piece of furniture. The stocking guide here, one centimetre of adult fish per two litres of water, is a rough freshwater starting point. It ignores surface area, filtration, temperament, and how much waste a species produces, which is why experienced keepers treat it as a ceiling rather than a target.

How to use it

  1. Measure the tank's outside length, width, and glass height in centimetres.
  2. Enter the substrate depth you plan to use, or zero for a bare-bottom tank.
  3. Add a rough percentage for rock, wood, and equipment displacement.
  4. Enter the total adult length of the fish you plan to keep.
  5. Check the water weight against the floor, and size the heater and filter from the water volume.

How it works

Water volume (L) = (length × width × height ÷ 1000) − substrate volume − decor share. Capacity (cm of fish) = water litres ÷ 2. Heater watts ≈ litres × 1. Filter flow ≈ litres × 4 per hour. In the default case: 160.0 L gross −16.0 L substrate −16.0 L decor = 128.0 L, so capacity is 64.0 cm of fish.

Example calculations

Example 1: An 80 × 40 × 50 cm tank

The box volume is 160.0 L. A 5 cm substrate takes 16.0 L and decor takes another 16.0 L, leaving 128.0 L. That weighs about 128 kg and supports roughly 64 cm of adult fish, with a 128 W heater and a 512 L/h filter.

Example 2: A large 120 × 50 × 60 cm tank

This tank holds 270 L of water and weighs about 270 kg before glass and stand. Capacity is 135 cm of fish, and the planned 80 cm of fish fills 59.3% of it. A 270 W heater and a 1,080 L/h filter match the volume.

Example 3: A small 45 × 30 × 30 cm tank

With a thin substrate and modest decor, the water volume is 33.2 L. That is only 16.6 cm of adult fish, so the planned 12 cm is 72.3% of capacity. Small tanks swing in temperature and chemistry quickly, which makes the margin for error much smaller.

What the result means

The water volume drives everything else. Heater wattage is usually sized for the difference between tank temperature and room temperature, so a cold room needs more watts per litre than a warm one. Filter flow is normally quoted as a multiple of tank volume per hour, and four times is a reasonable freshwater baseline; messy fish and saltwater systems need more. Stocking is the number most often pushed too far. The centimetre-per-two-litres rule works reasonably for slim community fish, but it understates the load from goldfish, plecos, and cichlids, which produce far more waste per centimetre. Surface area, filtration, and water-change routine matter more than litres alone, and a tank that is overstocked on paper can still thrive with excellent filtration and frequent changes.

Common mistakes

  • Using the manufacturer's box volume as the water volume.
  • Forgetting that substrate and rock displace a significant share of the water.
  • Putting a large tank on a floor or stand that cannot carry the weight.
  • Stocking by the tank's empty volume rather than the real water volume.
  • Sizing a heater for the tank volume without considering the room temperature.
  • Assuming a filter rated for the tank volume is enough for messy fish.

Assumptions and limits

  • Tank dimensions are measured in centimetres and the tank is rectangular.
  • The substrate is level and the decor share is a reasonable estimate.
  • Water density is about 1 kg per litre, ignoring dissolved salts.
  • The stocking rule is the freshwater one centimetre per two litres of water.
  • The tank is filled to the intended water line, not to the rim.

Frequently asked questions

How do I calculate aquarium volume in litres?

Multiply length, width, and height in centimetres, divide by 1,000, then subtract the substrate and a share for decor. The result is the actual water volume, which is lower than the box volume.

How much does a filled tank weigh?

Water weighs about 1 kg per litre, so a 128 litre tank holds 128 kg of water before glass, substrate, rock, and the stand. Check the floor loading for anything above about 100 litres.

How many fish can my tank hold?

The common freshwater guide is one centimetre of adult fish per two litres. It is a starting point only; surface area, filtration, temperament, and waste output matter more, and some species need far more room.

What size heater do I need?

A rough guide is about one watt per litre for a 5 to 7 °C rise above room temperature. Colder rooms, larger tanks, and open tops need more, and two smaller heaters can be safer than one large one.

How much filter flow does a tank need?

About four times the water volume per hour for a typical freshwater community, and more for messy or large fish. Check that the filter's rated flow is measured with media installed, not empty.

Does decor really reduce the water volume?

Yes. Rock, wood, and equipment displace water, and a heavily scaped tank can lose ten to fifteen percent of its volume. Enter a realistic percentage rather than assuming zero.

Sources

This is an educational estimate, not animal husbandry advice. Stocking rules vary by species and system, and tank weight can affect floor safety. Research the needs of each species and check the structural loading before filling a large tank.

2026 update

How to use the professional output

This page is not just a formula box. The result is designed to be checked, compared, and taken away.

  • Professional worksheet. The result includes the inputs used, the method and scope, and a one-variable sensitivity check for finance calculators.
  • A/B scenarios. Save two input sets in the browser and compare the primary, secondary, and breakdown figures side by side.
  • Print / PDF and CSV. Print a branded worksheet, or export the year-by-year table when the calculator produces one.

The formulas and assumptions above still govern the number. The worksheet makes the estimate auditable; it does not make it a lender quote, tax return, or personalized advice.

Calccc Editorial Team · Updated 2026-11-18

Prepared by Calccc Editorial Team as an educational estimate. This page is not a licensed professional review and is not financial, medical, legal, or tax advice.

Editorial estimate prepared by the Calccc Editorial Team; not a licensed professional review.