What this calculator does
Aquarium volumes are quoted as if the tank were a perfect empty box, but water never fills the whole box. Gravel, sand, wood, and rock all take up space, and the water line usually sits below the rim. The difference matters: a "160 litre" tank may hold only 128 litres once the substrate and decor are in, and every calculation that follows, from stocking to heater size to filter flow, should use the real water volume. Weight matters too, because water is heavy and a filled tank on an upper floor is a structural load, not just a piece of furniture. The stocking guide here, one centimetre of adult fish per two litres of water, is a rough freshwater starting point. It ignores surface area, filtration, temperament, and how much waste a species produces, which is why experienced keepers treat it as a ceiling rather than a target.
How to use it
- Measure the tank's outside length, width, and glass height in centimetres.
- Enter the substrate depth you plan to use, or zero for a bare-bottom tank.
- Add a rough percentage for rock, wood, and equipment displacement.
- Enter the total adult length of the fish you plan to keep.
- Check the water weight against the floor, and size the heater and filter from the water volume.
How it works
Example calculations
Example 1: An 80 × 40 × 50 cm tank
The box volume is 160.0 L. A 5 cm substrate takes 16.0 L and decor takes another 16.0 L, leaving 128.0 L. That weighs about 128 kg and supports roughly 64 cm of adult fish, with a 128 W heater and a 512 L/h filter.
Example 2: A large 120 × 50 × 60 cm tank
This tank holds 270 L of water and weighs about 270 kg before glass and stand. Capacity is 135 cm of fish, and the planned 80 cm of fish fills 59.3% of it. A 270 W heater and a 1,080 L/h filter match the volume.
Example 3: A small 45 × 30 × 30 cm tank
With a thin substrate and modest decor, the water volume is 33.2 L. That is only 16.6 cm of adult fish, so the planned 12 cm is 72.3% of capacity. Small tanks swing in temperature and chemistry quickly, which makes the margin for error much smaller.
What the result means
The water volume drives everything else. Heater wattage is usually sized for the difference between tank temperature and room temperature, so a cold room needs more watts per litre than a warm one. Filter flow is normally quoted as a multiple of tank volume per hour, and four times is a reasonable freshwater baseline; messy fish and saltwater systems need more. Stocking is the number most often pushed too far. The centimetre-per-two-litres rule works reasonably for slim community fish, but it understates the load from goldfish, plecos, and cichlids, which produce far more waste per centimetre. Surface area, filtration, and water-change routine matter more than litres alone, and a tank that is overstocked on paper can still thrive with excellent filtration and frequent changes.
Common mistakes
- Using the manufacturer's box volume as the water volume.
- Forgetting that substrate and rock displace a significant share of the water.
- Putting a large tank on a floor or stand that cannot carry the weight.
- Stocking by the tank's empty volume rather than the real water volume.
- Sizing a heater for the tank volume without considering the room temperature.
- Assuming a filter rated for the tank volume is enough for messy fish.
Assumptions and limits
- Tank dimensions are measured in centimetres and the tank is rectangular.
- The substrate is level and the decor share is a reasonable estimate.
- Water density is about 1 kg per litre, ignoring dissolved salts.
- The stocking rule is the freshwater one centimetre per two litres of water.
- The tank is filled to the intended water line, not to the rim.
Frequently asked questions
How do I calculate aquarium volume in litres?
Multiply length, width, and height in centimetres, divide by 1,000, then subtract the substrate and a share for decor. The result is the actual water volume, which is lower than the box volume.
How much does a filled tank weigh?
Water weighs about 1 kg per litre, so a 128 litre tank holds 128 kg of water before glass, substrate, rock, and the stand. Check the floor loading for anything above about 100 litres.
How many fish can my tank hold?
The common freshwater guide is one centimetre of adult fish per two litres. It is a starting point only; surface area, filtration, temperament, and waste output matter more, and some species need far more room.
What size heater do I need?
A rough guide is about one watt per litre for a 5 to 7 °C rise above room temperature. Colder rooms, larger tanks, and open tops need more, and two smaller heaters can be safer than one large one.
How much filter flow does a tank need?
About four times the water volume per hour for a typical freshwater community, and more for messy or large fish. Check that the filter's rated flow is measured with media installed, not empty.
Does decor really reduce the water volume?
Yes. Rock, wood, and equipment displace water, and a heavily scaped tank can lose ten to fifteen percent of its volume. Enter a realistic percentage rather than assuming zero.
Sources
2026 update
How to use the professional output
This page is not just a formula box. The result is designed to be checked, compared, and taken away.
- Professional worksheet. The result includes the inputs used, the method and scope, and a one-variable sensitivity check for finance calculators.
- A/B scenarios. Save two input sets in the browser and compare the primary, secondary, and breakdown figures side by side.
- Print / PDF and CSV. Print a branded worksheet, or export the year-by-year table when the calculator produces one.
The formulas and assumptions above still govern the number. The worksheet makes the estimate auditable; it does not make it a lender quote, tax return, or personalized advice.