The short answer: 350 °F is about 177 °C, which recipes round to 175 °C or 180 °C. A fan (convection) oven usually runs about 20 °C cooler than the conventional setting for the same result, so 180 °C conventional becomes 160 °C fan. Gas mark 4 is the same 350 °F. Because dials are coarse and thermostats cycle, treat every conversion as a starting point and check the oven with a thermometer.

Key takeaways

  • °C = (°F − 32) × 5/9. Recipes then round to the nearest 5 or 10 °C because dials move in steps.
  • Fan ovens need about 20 °C less. Many manuals say 20 °C, some say 15 °C, so check the manual for your model.
  • Gas marks are a separate scale. Mark 4 means 350 °F or 180 °C conventional, not 4 °C of anything.
  • Thermostats drift. A 10–25 °F offset is common, and an oven thermometer reveals it.
  • Food-safety temperatures are internal, not dial settings. The oven’s air temperature does not prove the center is cooked.

Converting Fahrenheit to Celsius at oven temperatures

The formula is the same one used for weather: subtract 32, multiply by 5, divide by 9. At oven temperatures the arithmetic is dominated by the 9/5 scaling, so the result changes quickly: each 25 °F step is about 14 °C. A recipe at 350 °F converts to 176.7 °C. Setting 175 °C leaves you 1.7 °C low; setting 180 °C leaves you 3.3 °C high. Both are within the tolerance of most home ovens, which is why either appears in recipes.

The rounding conventions are worth knowing because they differ by country. American recipes use 25 °F steps and often list 350 °F, 375 °F, and 400 °F. European recipes use 5 or 10 °C steps and list 180 °C, 190 °C, and 200 °C. British recipes may use gas marks. None of these are exact conversions of one another; they are round numbers chosen to match dials.

°F °C (exact) Dial °C Fan °C Gas mark
225 107 110 90 ¼
250 121 120 100 ½
275 135 140 120 1
300 149 150 130 2
325 163 170 150 3
350 177 180 160 4
375 191 190 170 5
400 204 200 180 6
425 218 220 200 7
450 232 230 210 8
475 246 240 220 9
500 260 260 240 —

Fan ovens: same air, more heat transfer

A fan circulates hot air across the food, which raises the convective heat-transfer rate and strips moisture from the surface. At the same thermostat setting, food browns faster and dries more than in a still oven. The standard correction is to lower the set temperature by about 20 °C (25 °F), or to keep the temperature and shorten the time by 10–15%. Many manufacturers print the exact figure in the manual; where they do, follow it rather than a general rule.

Fan ovens also heat faster and recover temperature more quickly after the door closes, so preheat times are often shorter. Multiple trays bake more evenly because the air moves between them, though a strong fan can push delicate batters to one side. Some models let you run the fan with a lower speed or turn it off entirely; a cheesecake or a sponge that domes unevenly may do better in conventional mode.

Fan and conventional are not interchangeable in both directions. A fan oven at 160 °C is not the same as a conventional oven at 160 °C, and a recipe developed for a fan oven may fail in a still oven at the same number. When a recipe states the oven type, trust the type before the number.

Gas marks and vague dials

The gas mark is a numbered scale from ¼ to 9 used in British and Irish recipes. It is not a temperature and it is not linear in a strict physical sense; it is a set of named settings that map approximately to the table above. Mark 4, the most common baking setting, is 350 °F or 180 °C conventional, and 160 °C in a fan oven.

Older recipes also use words. “Slow” usually means about 300 °F or 150 °C, “moderate” 350–375 °F or 180–190 °C, “hot” 400–425 °F or 200–220 °C, and “very hot” 450–475 °F or 230–240 °C. These ranges exist because the same word meant different things in different kitchens. Convert the word to a range, then choose the middle and watch the food.

Why the dial and the oven disagree

A thermostat does not hold a constant temperature. It switches the element on and off around a set point, letting the oven fall several degrees, then overshoot several degrees. A 350 °F oven may swing between 335 °F and 365 °F, and its average may sit 10–15 °F away from the dial. Mechanical dials drift with age, and a new oven can be off by 15–25 °F.

An inexpensive oven thermometer on the center rack, read after 20 minutes, gives you the average the dial does not. If it consistently reads 25 °F low, set the dial 25 °F higher, or use the calibration offset if the oven has one. Preheat fully — 15–20 minutes for most ovens, longer if you are baking on a stone or in a heavy dish. Opening the door drops the temperature by 25–50 °F, so use the window and the light.

Pan choice changes the result too. Dark metal and glass absorb radiant heat and brown faster; reduce the temperature by about 25 °F or check several minutes early. A bright pan reflects heat and slows browning. Rack position shifts the balance between radiant heat from the element and moving air, which is why the same recipe can behave differently on the top and middle racks.

High altitude changes the physics

At altitude, lower air pressure means water boils below 100 °C: roughly 95 °C at 1,500 meters and 93 °C at 2,000 meters. Baked goods rise more because leavening gases expand further, then may collapse when the structure cannot set in time. Sugar solutions reach higher concentrations before boiling, so candies and syrups need different target temperatures.

Typical adjustments are to raise the oven temperature slightly, reduce baking powder and sugar, add a little liquid, and increase flour. There is no single conversion factor because the effect depends on the recipe. Published high-altitude versions of a recipe are more reliable than a formula applied to a sea-level one.

Food safety temperatures are not oven settings

The dial describes the air in the oven. Safety depends on the internal temperature of the food, which lags well behind the air. US guidance sets poultry at 165 °F (74 °C), ground meat at 160 °F (71 °C), and whole cuts of pork, beef, and lamb at 145 °F (63 °C) with a three-minute rest. Leftovers and casseroles should be reheated to 165 °F. Hot food is held at 140 °F (60 °C) or above, cold food at 40 °F (4 °C) or below, and the range between is the danger zone.

An oven set to 350 °F does not guarantee that the center of a roast has reached 145 °F; only a thermometer does. The Celsius values above are conversions of Fahrenheit-defined US standards. For safety, use the Fahrenheit number or round the Celsius value up, not down.

Worked examples

425 °F. (425 − 32) × 5/9 = 218.3 °C, dialed as 220 °C conventional or 200 °C fan.

180 °C conventional. 180 × 1.8 + 32 = 356 °F, dialed as 350 °F. The fan equivalent is 160 °C.

200 °C fan. Add 20 °C to get 220 °C conventional, which is 428 °F, dialed as 425 °F.

500 °F. 260 °C, usually the maximum of a home oven and the setting for pizza and blistering vegetables.

160 °C conventional. 320 °F, with a fan equivalent of 140 °C.

Frequently asked questions

What is 350 °F in a fan oven?

350 °F is 177 °C conventional. Subtract about 20 °C for the fan, giving roughly 157 °C, which you would set as 160 °C.

Is 180 °C the same as 350 °F?

Approximately. 350 °F is 176.7 °C and 180 °C is 356 °F. Recipes treat them as equivalent because dials cannot do better.

How much should I reduce the temperature for a fan oven?

About 20 °C or 25 °F. Some manufacturers specify 15 °C, some 25 °C, so check the manual for your model.

Why does my oven burn food at the recipe temperature?

The thermostat may be running hot, the pan may be dark or glass, or the fan may be on when the recipe assumed a still oven. Check with an oven thermometer and adjust one variable at a time.

What is gas mark 4 in Celsius?

Gas mark 4 is 350 °F, or 180 °C conventional and 160 °C fan.

Can I leave a meat thermometer in the oven?

Yes, if it is a leave-in probe rated for oven use. Check the maximum temperature on the probe and cable, and route the cable away from the element.

Further reading

Keep exploring

Read next Hex to RGB: Color Codes, Channels, and Alpha A hex code is three base-16 channel values in one string. Learn how RR, GG, and BB become… Read next Density Conversion: kg/m³, g/cm³, and lb/ft³ Density is mass per volume, and the metric and imperial units are linked by exact factors. Learn the… Read next Roman Numerals: Rules, Subtractive Notation, and Limits Learn the seven Roman numeral symbols, the six subtractive pairs, standard-form rules, and why the system stops at…

Decision path

Use this guide in a decision

Open Conversion Decision Center Open companion solver